Hallway Accident is the second escape room in Escape Simulator in Adrift in Space.
In this quick guide, you’ll learn how to complete Hallway Accident in Adrift in Space in Escape Simulator.
This includes the connector pins, the drone, and the damaged cards.
- Collect all of the items
- Remove the panels
- Connect the connector pins
- Insert the metals
- Replicate a Cone
- Replicate a Thruster
- Fix the Drone
- Laser the wall pieces
- Read the cards
1. Collect all of the items

Click on the green thumbprint next to the power switch to open the compartment.
Collect all of the essential items inside the compartment.
This includes two panel remover tools, a drone recipe, a read/write keycard, replicator instructions, and a pin box.
Open the pin box and collect all of the connector pins inside of it.
2. Remove the panels

Use the panel removal tool to remove the panels on the ground.
There should be 6 panels in total.
Move the panels to the sides of the room.
Collect the connector pins inside the panels.
3. Connect the connector pins

Now, you need to connect the connector pins from the power switch to the metal replicator.
Open the power switch.
Turn off the power switch before you place the connector pin in the slot under it.
Keep in mind that if you don’t turn the power switch off, you won’t be able to place the connector pin!
Place the rest of the connector pins in each slot on the ground.
Turn on the power switch.
4. Insert the metals

Open the hatch door and turn the blue switch off.
Collect the metal rods and metal pieces on the ground.
They are located next to the wall piece.
Collect the drone recipe on the ground.
Now your inventory should contain a couple of drone recipes.
This includes the “Cone” and the “Thruster”.
Insert all of the metals in the “Insert Metal” compartment.
5. Replicate a Cone

According to the first drone recipe, you need 8 blue squares and 1 black square in the middle to replicate a cone.
Open the metal replicator and select the blue square, black square, and blue square respectively.
Enter “4”, “1”, “4” respectively and click on “Start”.
Collect the Drone Cone.
6. Replicate a Thruster

According to the second drone recipe, you need 1 black square, 1 white square, 1 black square, 1 white square, and so on to replicate a thruster.
Open the metal replicator and select the black square, the white + black square, and the black square respectively.
Enter “1”, “8”, “0” respectively and click on “Start”.
Collect the Drone Thruster.
7. Fix the Drone

Inspect the Drone in your inventory.
Now, you need to fix the Drone by placing the Drone parts that you’ve replicated using the Metal Replicator.
Place the Drone Cone at the bottom of the Drone.
Place the Drone Thruster at the front of the Drone.
8. Laser the wall pieces

Change the drone to “Rotation” mode.
Rotate the drone until it points toward the wall pieces.
Change the drone to “Position” mode.
Click on the “Laser” button to enable the laser.
Laser the wall pieces that are blocking the door using the drone.
9. Read the cards

Collect the first damaged keycard on the ground (under the power switch).
Collect the second damaged keycard on the ground (next to the wall piece).
Insert the first damaged keycard into the card reader and memorize the numbers.
Insert the second damaged keycard into the card reader and memorize the numbers.
The idea is to match the numbers of the two damaged keycards to the red keycard.
Lastly, insert the red keycard and enter 0, 1, 0, 1, 0, 1, 1, 0, 1.
Insert the red keycard into the thumbprint slot next to the door and click on the thumbprint to escape the Hallway Accident room in Adrift in Space!
Further reading
Escape Simulator Emergency Awakening Walkthrough